Loading

Saturday, September 5, 2009

Stop 7B Error: Windows XP Embedded SP2 Feature Pack 2007

The "Stop 7B" error occurs when your configuration is missing a component that is required to boot your device. Examples of these components include the PCI bus and the IDE controller.

 
Resolution
Be sure the following components are in your configuration:
  • An IDE controller
  • The Primary IDE Channel component
  • The Secondary IDE Channel component
  • A disk drive component

Note
Windows XP Embedded has three components that contain the name Disk Drive and three .inf files that identify their drivers with the name Disk Drive. To determine the generic disk drive component, you must inspect the properties of each component, and then select the one with the cmiPNPDevID property set to GenDisk.

If you created a configuration based on a Target Analyzer .pmq file, verify that the run-time image is installed on the same device. If it is installed on a different device, this error may occur due to missing drivers for critical devices.

 

No comments:

Post a Comment